Table of Contents
This article describes how to disassemble an Xbox Just one controller if it requirements repairs, retain an eye out for possible issues and what unique instruments you’ll have to have. Xbox One controllers are broadly regarded as a person of the best controllers in movie online games, but they nonetheless fall short from time to time.
You can use a Torx bit in a screwdriver or with a socket wrench, or use a unique Torx screwdriver, but it need to be a T-8 protection Torx.
You can notify the distinction between a typical Torx and a protection Torx by the compact hole identified in the tip of a security Torx. Without the need of this modest hole, a conventional T-8 Torx will not fit the Xbox 1 controller screws.
How to disassemble the controller for the Xbox A single?
For the pry instrument, you can use anything at all thin ample to healthy in the gap involving the controller box and the conclusion caps. If probable, test to use a plastic resource to steer clear of detrimental your controller circumstance.
Here’s how to disassemble the Xbox A single controller:
- From the exact deal with, get rid of the second screw.
- Repeat the very same technique on the other deal with, remove the very last two screws and the controller will tumble aside.
- You now have obtain to the noisy motors, triggers, and some additional screws that you can depart alone except if you want to switch specific components on the circuit board. To obtain most of the other components, clear away the assembly from the entrance housing and switch it over.
- You could thoroughly clean the buttons, analog sticks, D-pad ring, and D-pad from this vantage point, between other matters.
- When completed, only carry out the prior guidelines in reverse to reassemble the controller. Place the controller assembly back again into the entrance scenario, switch the back again situation, substitute and tighten all the screws, then replace the cope with handles and the battery address.
Undertaking Xbox Just one Controller Repairs
The moment you’ve efficiently disassembled your Xbox Just one controller, you can try repairs. Some difficulties can be solved by just cleansing the parts, while other individuals need changing the elements.
In some cases, advanced capabilities these types of as soldering are required to clear away and replace factors. In your experience, some of these repairs are very best left to the pros.
Other repairs are substantially less difficult, these as fixing or changing the d-pad ring. If your D-pad isn’t responding properly, attempt this brief repair:
- Use a pry instrument or tweezers to gently loosen the spring steel D-pad ring.
- Gently carry your arms on the d-pad ring so they utilize additional stress and reassemble. If that doesn’t resolve your dilemma, you may well have to have a new D-pad ring.
If your Xbox Just one controller isn’t doing work adequately and you have by now updated the firmware and executed primary troubleshooting like checking the batteries, the upcoming phase is normally to disassemble the controller.
Right here are some fixes that have to have disassembling your Xbox Just one controller, including tips on what to do just after opening the controller:
D-Pad Malfunction: Gently raise the spring assembly tabs to thrust them down with far more drive. Switch if vital.
Drifting thumbsticks: Clean or replace thumbstick assemblies as necessary.
