[jasonwinfieldnz] makes use of twelve modest powerbanks day to day – powering LED strips about his trampoline, presumably, to prevent the mess of wires and make the assembly simply transportable. On the other hand, if you have twelve powerbanks, you are going to locate you hogging all the household’s microUSB cables each and every so typically, as they finally discharge. This was not excellent more than enough for our hacker, and he determined to construct a charging station to refill them all at at the time.
If you will need 5 volts and quite a few amps, an ATX PSU isn’t your worst guess. From there, he only experienced to incorporate twelve microUSB connectors to – and condensed the total contraption into a gorgeous charging station. For the microUSB aspect, he hacked some microUSB cable finishes off and embedded them into the scenario. An embedded voltage and current module is of major support – permitting you see at a glance when charging has truly finished. Using copper tape as bus bars and banana plugs for charging enter, this venture is uncomplicated to create and solves the problem effectively.
The 3D printing data files and chopping templates are proper there on the job webpage, so if any of us hackers has a issue that twelve powerbanks could aid with, [Jason]’s undertaking is pretty repeatable. If your equipment are far more assorted, you could use a pegboard to establish a fashionable charging station for them! If, on the other hand, you have a single unit you need to plug many cords into, moldable plastic is there to aid.
